COBHAM Sea Tel 100 TVHD User Manual

Field Installation & Test Procedure, 4 Switch Dual Antenna Arbitrator
Panel Assembly, Sea Tel TV
Page i
Document No
99-145228-A2
Copyright © Sea Tel, Inc 2015 The information contained in this document is proprietary to Sea
Tel, Inc.. This document may not be reproduced or distributed in any form without prior written
consent of Sea Tel, Inc.
Form 99-144368-A
Approval:
Approval Routing
Position
Approving Authority
(Electronic Signature)
Product Manager Bobby Johns
Author Mike Needham
QMS Control: NONE
Revision History
Rev.
DCO
Description of Change
Date
A
Release of Document. Approval history is stored in Agile.
02/10/15
A1 Clerical changes. 06/18/15
A2 Clerical Changes after review 07/02/15

COBHAM Sea Tel 100 TVHD Specifications

General

Type	Marine Satellite TV Antenna
Antenna Diameter	100 cm
Frequency Range	10.7 - 12.75 GHz
Operating Frequency	Ku-band
Tracking	Automatic
Stabilization	3-axis
Azimuth Range	Unlimited
Mounting	Deck mount
Operating Temperature	-25°C to +55°C
Power Consumption	100W (typical)
Polarization	Linear
Compatibility	DVB-S2

Summary

Dual Antenna Configuration Principles

Antenna Installation Guidelines

Blockage Zone Plotting Procedure

Dual Antenna Arbitrator Panel Overview

Dual Antenna Arbitrator Panel Installation

Panel Placement and Wire Connections

Install the panel and connect control and ground wires to LMXPs.

Antenna Coax Cable Connections

Connect antenna coax cables to the relevant switch connectors.

LMXP Setup and Configuration

Primary LMXP Configuration Steps

Configure primary LMXP settings, including IP, blockage zones, and satellite search.

Secondary LMXP Configuration Steps

Configure secondary LMXP settings, IP, blockage zones, and satellite search.

Dual Antenna System Testing Procedure

Initial Verification and Primary System Test

Verify tracking and test primary system response to blockage/unblocking.

Secondary System Test and Final Verification

Test secondary system response and confirm overall system operation.