Maverick Boat Company, Inc. • 3207 Industrial 29th St. • Fort Pierce,
Florida 34946 • (772)-465-0631 or (888)-shallow • Fax: (772) 489-2168
Electric Head
The macerator is to be used only with direct discharge. Do not use macerator for dockside pump out of the holding tank. To
flush the head, make sure the intake valve is in the open position. The intake valve is located in the forward bilge access in
the console on the aft bulkhead. This supplies your head with the water it will need to operate correctly. Then press the toilet
switch and the waste is pushed into the holding tank. The macerator has nothing to do with the flushing of the toilet. The
macerator is only used for overboard discharge while outside the legal dumping limits. To discharge outside legal limits, open
the thru hull discharge valve located directly across from the intake valve located in the forward bilge access, turn the Y-Valve
to the direction of the macerator, and flip macerator switch to the “ON” position. The Y-Valve is also located in the forward
bilge access.
To Next Page
