11
8 - PERSONAL PIN CODE
The PIN code should be personalised. The system is delivered
with the code 1111 and it must be replaced by a four digits
code without the number ‘0’ .
To program the system with your own four digit PIN code,
disarm the system, then proceed as follows:
• Open a door
• Turn the ignition On.
Keep the emergency panel button and button ‘A’ of the radio control
simultaneously pressed until a blink of the turn indicators occurs,
this indicates that you can now program a new PIN code.
• Push the button on the emergency panel for the number of times
corresponding to the first digit of the new PIN code.
The led will blink everytime you press the button, a longer blink will
confirm that the right PIN code digit has been input.
Proceed in the same way for the further 3 digits.
• Turn the ignition OFF at the ackowlegement of the fourth
digit.
• Repeat the new PIN code entry.
• If this PIN code is the same as the previous the system will
store it. The storage confirmation is given by a 3 s blink
of the turn indicators and of the LED.
To exit the program at any time, close the opened door and
the old PIN will not be modified.
8 - PERSONAL PIN CODE GLOBE 3100
PERSONAL PIN CODE