Fitting instructions - BRIDGE 4100
22
VOLUMETRIC ULTRASONIC SENSOR (IF APPLICABLE)
Fit the transducers at the top of the pillars each side of the windscreen or rear window, making
sure, taking care that they are not covered when the sunvisors are down. If the car is equipped
with sliding sunroof, do not fit the transducers on the dashboard. Check the right position of the
transducers during the functional test of the system. No adjustment is required for the volumetric
ultrasonic sensor.
It adapts to all types of vehicle, regardless of the volume of the passager compartment.
ANTENNA
The position of the antenna is of fundamental importance to the operation of the radio
controls.
The wire must not be cut, wound, connected to other wires or to the bodywork and must be kept
separate from the wiring harness. Position the antenna at least 20 mm away from metallic
parts.
EMERGENCY OVERRIDE PANEL
Install on the dashboard in an accessable position. The LED must olso be visableto the user.
In addition to its deterrent function, the panel (LED + push button) is used for programming
and for emergency override.
2 31
06DE2143E.pmd 07/02/2008, 15.1522
To Next Page
Loading...
