Cobra CR6 User Manual

16
Part 6 Gas Conversion
Oven
Main Burner - CR6 Model Only
1. Ensure that the gas supply is turned off at the
main supply.
2. Open the oven door and remove the oven rack,
oven tray and the flame baffle from inside the
oven.
3. Remove the single screw securing the oven
burner to the oven and pull out the main burner
from the oven.
4. The main injector will now be exposed at the
rear of the oven and can be unscrewed and
removed using a 13 mm (
1/
2
” A/F) spanner.
5. Remove the main burner injector and replace
with the correct size injector. (Refer to the ‘Gas
Specifications’ table at the rear of this section).
6. Refit the main burner to the oven and secure in
position with the single screw.
Main Burner - CR9 Model Only
1. Ensure that the gas supply is turned off at the
main supply.
2. Open the oven door and remove the oven rack,
oven tray and the flame baffle from inside the
oven.
3. Remove the 2 screws securing the oven burner
bracket to the oven and pull the main burner
out the from of the oven.
4. The main injector will now be exposed at the
rear of the oven and can be unscrewed and
removed using a 13 mm (
1/
2
” A/F) spanner.
5. Remove the main burner injector and replace
with the correct size injector. (Refer to the ‘Gas
Specifications’ table at the rear of this section).
6. Refit the main burner to the oven and secure in
position with the 2 screws.
Burner Securing
Screws
Burner Securing
Screw

Cobra CR6 Specifications

General

Brand	Cobra
Model	CR6
Category	Ranges
Language	English