Cobra XRS 9670 - Using Program Mode; Entering and Navigating Program Mode; Changing Settings; Exiting Program Mode

Three beeps
To Use Program Mode
Press and hold the
Program/Mute button
for two seconds.
.... .• Set/City Button
Press and release
.. e Select/Dim Button
Press and release
.. e Program/Mute Button
Press and hold/Press and release
Program will appear.
PROGRAM
Then brief programming
instructions will scroll through
the display three times.
While the programming
instructions are
scrolling, press and
release the Select/Dim
button to cycle through
the user modes.
One beep with
each button press
As each mode is displayed,
the current setting for that
mode will be shown.
One beep
One or two beeps,
depending on your
selection
The setting you select will
be shown.
When you exit Program
mode, the new setting will
automatically be saved and
EXIT PROGRAM and Settings
Saved! will appear in the display.
Settings
Saved!
EXIT
PROGRAM
With the user mode you
wish to change displayed,
press and release
the Set/City button to
change the setting.
To move to the next
selection, press the
Select/Dim button again.
-1---
When you have finished
programming any or
all of the user modes,
press and release the
Program/Mute button
to exit Program mode.
Or simply wait ten
seconds without
pushing any buttons.
Nothing Comes Close to a Cobra- []