23
11. Control unit operation
Activate the required program (P1–P3) by pressing the
corresponding program button. During selection an
audible signal can be heard and the program button is
illuminated. On the display the selected program appears
with the adjusted range in rpm:
Display adjustments
– P1–P2 speed
– P3 torque
Pump operation
ON/OFF
Display adjustments
– P3 torque in Ncm
– P1–P2 speed in rpm
Error messages (see page 27)
– Motor temperature too high
– Motor connection
Changing the program (P1–P3)
When switching on the Osscora surgical set ensure that the LED displays on the buttons and the display
itself are all on.
To Next Page
Loading...
