Operation
3.8 Hovering Height Adjustment
To auto-hover at your desired height, manoevere the drone up and down using the left thumb
stick. At your desired height, simply remove your thumb from the thumbstick and the drone will
auto-hover. You can continue to use the right thumbstick to control the direction of ight, whilst
maintain the hover.
NOTE: Auto-hover will be aected by ying conditions. Fine tune/trim the drone if necessary.
3.9 Headless / Normal Modes
The drone can be operated in Headless and Normal Modes. Headless mode enables you to y the
drone without having to focus on the drone’s orientation i.e. where the head of the drone is in
relation to your position. This means that regardless of whether the head, one of the sides or the
tail of the drone is facing you, moving sideways to the left will always be left for example.
In Normal Mode however, the drone’s direction will be dependent upon the tail of the drone in
relation to your position. For example, if the drone’s tail is facing you and you manoeuvre it the
left, the drone will move left. However, if the head of the drone is facing you and you perform the
same manoeuvre, you will nd the drone will move right.
To change to Headless Mode:
a. During ight, depress the right thumb stick into its centre for approximately 2 seconds until
you hear 8 beeps and the LED lights under the drone will ash every 4 seconds
b. To change to normal mode, depress the right thumb stick into its centre for approximately 2
seconds and you will hear one long beep. In normal mode, the LED lights under the drone will
not ash
NOTE:
• Headless mode is great for beginners
• If you are operating the drone in Normal Mode, we recommend that you always start by having the
drone’s tail facing you therefore the head of the drone and camera should face away from you
• The drone’s default setting will be in Normal Mode. If you change the drone to Headless Mode and
switch OFF the drone, the drone will default back to Normal Mode. If you only land the drone and do
not switch it OFF, it will remain in Headless Mode
• You can switch between Normal and Headless Modes both during ight and after you have paired
the remote control and drone before ying
To Next Page
Loading...