Installing the antenna
Automatic Whip Antenna 3040 Installation Handbook 15
Mounting bracket
The antenna must be mounted on a sturdy metal plate (at least
8 mm (0.3 in) thick). The mounting bracket and fixing should
be able to withstand any vibrations induced from the vehicle
travelling over an off-road surface. A strong metal plate that is
large enough to support the antenna will also provide efficient
earthing. The plate must have a 15 mm (0.6 in) hole to accept
the mounting screw.
The bracket should be located so that any flexing of the
antenna assembly does not damage the panels of the vehicle.
The installed antenna should enable easy access to the
connectors.
CAUTION
If the antenna is front-mounted, it should be
mounted on the side opposite to the driving
position.
NOTE
You should consider any overall height
restrictions that are relevant to your vehicle.
To Next Page
Loading...
Need help?
General
