Compliance
Automatic Whip Antenna 3040 Installation Handbook 33
FCC compliance
FCC Part 15 compliance
Any modifications made to the 3040 Automatic Whip
Antenna that are not approved by the party responsible for
compliance may void your equipment’s compliance under
Part 15 of the FCC rules.
The 3040 Automatic Whip Antenna has been tested and found
to comply with the limits for a Class B device, pursuant to
Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
switching the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
• reorient or relocate the receiving antenna
• increase the separation between the equipment and
receiver
• connect the equipment into an outlet on a circuit different
from that to which the receiver is connected
• consult the dealer or an experienced radio/TV technician
for help
To Next Page
Loading...
Need help?
General
