Code Alarm caSEC - Page 24

24 caSEC revB
6 - Security: Controls security functionality - ON / OFF.
ON - Full security functionality.
OFF - The security system does not trigger. Panic, Remote Start and all
other convenience features operate as normal.
ON w/OEM Remote Start Compatibility - This will prevent a vehicle’s factory
remote start from triggering the security system when activated. The system
will use the ignition input to shunt shock and door inputs until 5 seconds after
they clear. If the alarm is triggered prior to ignition on, then ignition will not
shunt/cancel the alarm’s triggered state. Also, note that the ignition input will no
longer serve as a trigger if this option is selected on.
7 - Anti-Hijack Mode: Controls carjack mode - ON / OFF.
OFF - Standard security system operation.
ON - Enables Carjack mode functionality as described in the owners
manual.
8 - Ground While Armed / Orange ( - ) Output: Controls the output of the orange
wire. This wire will either supply a ( - ) output when armed OR disarmed.
9 - DBI Port Protocol: Determines the protocol type in which the DBI port uses to
interface with external modules.
DBI Protocol
ADS Protocol
10 - Arm/Disarm Chirps: Determinesthenumberofchirpsandparkinglightashes
when the system is armed/disarmed.
Standard - 2chirps/lightasheswitharm,1chirp/lightashwithdisarm.
Inverted - 1chirp/lightashwitharm,2chirps/lightasheswithdisarm.
11 - LED Indicator: Control of the status LED when the system is armed / locked.
ON - LEDwillashwhensystemisarmed/locked
OFF - LEDwillnotashwhensystemisarmed/locked.Onlyappliesto
normal operation (armed/locked) and does not affect programming, valet
mode, diagnostics, passive lock countdown or PTN.