Code Blue LS1000 - Programming Beacon;Strobe Operating Modes; Beacon;Strobe Mode Selection Chart

LS1000
Administrator Guide
Code Blue ● 259 Hedcor Street ● Holland, MI ● 4923 USA ● 800.205.7186 ● www.codeblue.com Rev 6/2021 page 52 of 57 GU-164-A
The Steadyburn Mode will be ON in dark or night ambient environments and OFF in bright or daylight
ambient environments. The S-1050 LED Beacon/Strobe has two built-in photo response features: (a)
dawn/dusk transition delay of 15-30 minutes and (b) transient light acknowledgement delay of at least 3
minutes.
PROGRAMMING PRIMARY & SECONDARY MODES
1. Remove power from unit.
2. Short the Yellow wires together.
3. Restore power to the unit and wait until the unit begins to flash. Once the unit begins to flash,
remove the short. The unit will alternately demonstrate the Secondary-Flash Mode and Primary-
Steadyburn Mode that will be displayed during operation. For approximately 4 seconds the
Secondary-Flash Mode will be demonstrated, followed by the Primary-Steadyburn Mode.
4. To select the next mode of operation, momentarily short the yellow wires. The unit will cycle to the
next mode in the list above.
MODE NUMBER PRIMARY-STEADYBURN
MODE
SECONDARY-FLASH
MODE
1
High
Single - 60 FPM
2
OFF
Single - 60 FPM
3
Low
Single - 60 FPM
4
High
Single - 150 FPM
5
OFF
Single - 150 FPM
6
Low
Single - 150 FPM
7
High
Single - 375 FPM
8
OFF
Single - 375 FPM
9
Low
Single - 375 FPM
10
High
Neobe - 75
11
OFF
Neobe - 75
12
Low
Neobe - 75
13
High
Neobe - 150
14
OFF
Neobe - 150
15
Low
Neobe - 150
16
High
Double - 125
17
OFF
Double - 125
18
Low
Double - 125
19
High
Double - 250
20
OFF
Double - 250
21
Low
Double - 250