4/14/2016
D014465 CR1400 CR1000 CR2300 CR2600 CR3600 CR44X5 CR8000 CR900FD CR6000 CR5000 T500 Client Version ICD
Page 94 of 106
© 2013-2016 The Code Corporation
12393 South Gateway Park Place Suite 600, Draper, UT 84020
(801) 495-2200
FAX (801) 495-0280
In-Stand Illumination
Axis Control
CR5000:
CR5000RTC:
70
(#112)
When the reader is placed on a surface and Stand Detection is
enabled, register 2B2 will be set to the value in this register.
Note: Applies to CR5000 & CR5000RTC readers only.
Keywords: #Stand, #StandModes
Out-of-Stand
Illumination Axis
Control
CR5000:
CR5000RTC:
70
(#112)
When the reader is lifted up and Stand Detection is enabled,
register 2B2 will be set to the value in this register.
Note: Applies to CR5000 & CR5000RTC readers only.
Keywords: #Stand, #StandModes
In-Stand Ignore
Duplicate Barcode (ms)
Valid Range: 0 to 7FFFFFFF (#2147483647) Milliseconds
When the reader is placed on a surface and Stand Detection is
enabled, register 159 will be set to the value in this register.
The CR5000 & CR5000RTC does not use register 21C (the
extended duplicate block time).
Note: Applies to CR5000 & CR5000RTC readers only.
Keywords: #Stand, #StandModes
Out-of-Stand Ignore
Duplicate Barcode (ms)
When the reader is lifted up and Stand Detection is enabled,
register 159 will be set to the value in this register. The
CR5000 & CR5000RTC does not use register 21C (the extended
duplicate block time).
Note: Applies to CR5000 & CR5000RTC readers only.
Keywords: #Stand, #StandModes
In-Stand Illuminate-on-
Motion
When the reader is lifted up and Stand Detection is enabled,
register 2E3 will be set to the value in this register.
Note: Applies to CR5000 & CR5000RTC readers only.
Keywords: #Stand, #StandModes