EasyManuals Logo

Code CR900FD User Manual

Code CR900FD
106 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #42 background imageLoading...
Page #42 background image
4/14/2016
D014465 CR1400 CR1000 CR2300 CR2600 CR3600 CR44X5 CR8000 CR900FD CR6000 CR5000 T500 Client Version ICD
Page 42 of 106
© 2013-2016 The Code Corporation
12393 South Gateway Park Place Suite 600, Draper, UT 84020
(801) 495-2200
FAX (801) 495-0280
Reg
Setting Name
Default (Hex)
Comment
42
Expect
Acknowledgement
From Host
0
0: Reader doesn’t wait for acknowledge
1: Reader will retransmit data when Host doesn’t acknowledge
receipt
This setting is used in conjunction with registers 08 and 1B to
configure the communication mode between standard “one-
way” and “two-way” modes.
For example, USB “two-way” native:
1B: 5 (USB Native)
08: 2 (packet mode)
42: 1 (expect response)
Persistence: Protected
Keywords: #Communications
43
JPEG Picture Quality
(percent)
32
(#50)
Valid Range: 0 to 64 (#100) Percent
0: Raw Image (No JPEG Compression)
1 To 100: JPEG Compression Quality Percent
Keywords: #PictureSettings
46
Prefix With Timestamp
0
47
MaxiCode Symbology
0
Binary Dip Switch
Bit
Controls
Value
0
MaxiCode Decoding, Mode 0
0: Disabled
1: Enabled
1
MaxiCode Decoding, Mode 1
0: Disabled
1: Enabled
2
MaxiCode Decoding, Mode 2
0: Disabled
1: Enabled
3
MaxiCode Decoding, Mode 3
0: Disabled
1: Enabled
4
MaxiCode Decoding, Mode 4
0: Disabled
1: Enabled
5
MaxiCode Decoding, Mode 5
0: Disabled
1: Enabled
6
MaxiCode Decoding, Mode 6
0: Disabled
1: Enabled
Note: This register has no effect on a CR900FD without the
proper 2D barcode decoding license.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Code CR900FD and is the answer not in the manual?

Code CR900FD Specifications

General IconGeneral
BrandCode
ModelCR900FD
CategoryBarcode Reader
LanguageEnglish

Related product manuals