Code CR900FD - Page 54

4/14/2016
D014465 CR1400 CR1000 CR2300 CR2600 CR3600 CR44X5 CR8000 CR900FD CR6000 CR5000 T500 Client Version ICD
Page 54 of 106
© 2013-2016 The Code Corporation  12393 South Gateway Park Place Suite 600, Draper, UT 84020  (801) 495-2200  FAX (801) 495-0280
Reg
Setting Name
Default (Hex)
Comment
9F
Standby Mode
Countdown Timer (ms)
FFFFFE0C
(#-500)
CR2300:
CR2600:
CR2600XHD:
CR3600:
CR3600DPM:
927C0
(#600000, 10
min)
CR4405:
EA60
(#60000, 1
min)
Valid Range: 0 to 7FFFFFFF Milliseconds.
This state: Standby (Lowest power usage)
Next state: Sleep ( < 2mA current – NON-USB devices ONLY)
Counts down to the end of Standby Mode. (Sleep mode NOT
active in cabled USB devices). To disable this timer, set the
register value to -1 as in the following example which disables
and saves the timer setting with the ‘C’ command:
C(9F)#-1
Standby Mode is the time after the Idle Mode Countdown
Timer has expired and before the Standby Mode Countdown
Timer has expired. There are many user and firmware events
that will reset the timer or send the reader back into a higher-
power mode; therefore it may seem that the timer is longer
than the value set.
Note: Only applies to readers using Bluetooth® communication
modes.
Keywords: #ReaderState
A1
Vibrate
1
0: Disabled
1: Enabled (vibration motor will be on at same time as speaker)
Note: if vibrate-only is desired, set speaker volume to 0 using
register 26.
Note: Readers with a vibration motor are the CR1400,
CR1400XHD, CR1428, CR2600, CR2600XHD, CR3600,
CR3600DPM and CR6000.
A2
Default Event Delay
(ms)
64
(#100)
CR5000:
CR5000RTC:
1
Valid Range: 0 to 7FFFFFFF Milliseconds
The Reader will pause for this amount of time between each
posting of the default event (used with “continuous read”
mode).
Note: Register C4 contains the list of valid events.
Keywords: #DefaultEvent