The default value of FF is the idle event. This means that
normally, no activity is occurring. However, if the value is set to
one of those shown in the list below, then that action will be
repeated continuously, unless interrupted by an external
trigger or command. Any event other than 0 or FF will prevent
the reader from entering power save mode.
This register also causes register 86 to be set to 0, unless
motion detection (F0) is selected as the default event.
Event numbers (same as register 39)
0: No Action
1: Keep Awake
2: Show Target
3: Read In Both Fields (Default)
5: Read In High Density field (FOI 0). See section 9.2
Note: The CR900FD does not have a High Density field (FOI 0)
6: Read In Wide field (FOI 1). See section 9.2
7: Take Picture
8: Read In Most Recently Successful Field
0D to 50 (#13 To #80): Custom events (handled by JavaScript)
DB (#219): Flash illumination and targeting
DC (#220): Perform “Phone connected” handler
DD (#221): Perform “Phone disconnected” handler
DE (#222): Perform “Cable disconnected” handler
DF (#223): Perform “Reader removed from charger” handler
E0 (#224): Perform “Reader placed in charger” handler
E1 (#225): Perform “Cable connected” handler
E2 (#226): Beep
F0 (#240): Detect motion
F1 (#241): Toggle Apple® KB mode (Bluetooth® KB mode only)
F2 (#242): Update behavior based on Stand Detection
F4 (#244): Perform “Reader placed in stand” handler
F5 (#245): Perform “Reader removed from stand” handler
FF (#255): Idle
Keywords: #Beep, #Charger, #DefaultEvent,
#MotionDetection, #Stand, #StandModes
To Next Page
Loading...
