Code CR900FD - Page 63

4/14/2016
D014465 CR1400 CR1000 CR2300 CR2600 CR3600 CR44X5 CR8000 CR900FD CR6000 CR5000 T500 Client Version ICD
Page 63 of 106
© 2013-2016 The Code Corporation  12393 South Gateway Park Place Suite 600, Draper, UT 84020  (801) 495-2200  FAX (801) 495-0280
Reg
Setting Name
Default (Hex)
Comment
FC
Keep reading barcodes
as long as button is
held down
0
0: Disabled (requires button to be released before next scan
occurs)
1: Enabled
Note: When enabled, register 159 should be greater than zero.
10C
Bluetooth® Connected
Cache Time (Seconds)
3
Valid Range: 0 to 7FFFFFFF Seconds
The time the last connection status received from the radio
remains valid.
If a request is made during this time since last radio query, the
cached status is returned. Otherwise, the Reader will query the
radio for connection status (which takes up to 1 second).
Note: Only applies to readers using Bluetooth® communication
modes.
10D
Grid Matrix Symbology
0
Binary Dip Switch
Bit
Controls
Value
0
Grid Matrix
0: Disabled
1: Enabled
All other bits are reserved
12D
Hong Kong 2 Of 5
Symbology
0
Binary Dip Switch
Bit
Controls
Value
0
Hong Kong 2 of 5 Decoding
0: Disabled
1: Enabled
Keywords: #2Of5
12F
Notify Of Packet
Rejection
1
0: Disabled
1: Beep 3 times
0x100xx: post event on No-Read, where the lower 8 bits
specify the event number. For example, 0x10009 to post
Event 0x09.
Specify the behavior when a packet is rejected because of
incorrect encryption key, incorrect packet protocol, or
CodeXML
®
Modems locked to a different Reader.
Note: Register C4 contains the list of valid events.
Keywords: #Beep, #DefaultEvent