Code CR900FD - Page 65

4/14/2016
D014465 CR1400 CR1000 CR2300 CR2600 CR3600 CR44X5 CR8000 CR900FD CR6000 CR5000 T500 Client Version ICD
Page 65 of 106
© 2013-2016 The Code Corporation  12393 South Gateway Park Place Suite 600, Draper, UT 84020  (801) 495-2200  FAX (801) 495-0280
Reg
Setting Name
Default (Hex)
Comment
181
Glare Detection
(Reduction)
0
0: Disabled
1: Enabled
Not available in the CR8000 because there is no off-axis
illumination.
1EA
Good Read Duration
(ms)
C8
(#200)
Valid Range: 0 to 7FFFFFF Milliseconds
For the CR8000 and CR8013, this the duration that the good
read hardware signal is asserted. For other readers, this is the
duration for which the good read indicator LED will be
illuminated and the pulse width of the good read signal on RTS.
Keywords: #GoodReadRTS
1F7
Platform configure
buttons and Stand
Detection
42
(#66)
CR2600:
CR2600XHD:
CR2300:
CR3600:
CR3600DPM:
2a
(#42)
CR4405:
2
Binary Dip Switch
Bit
Controls
Value
1
Button 1 Enable
0: Disabled
1: Enabled
3
Button2 Enable
0: Disabled
1: Enabled
5
Button4 Enable
0: Disabled
1: Enabled
6
Enable Stand Detection
0: Disabled
1: Enabled
Note: All other bits are Reserved.
To toggle Stand Detection, use CO(1F7)40 and CQ(1F7)40
Keywords: #StandDetect
20E
Motion Detection:
Start Delay (ms)
0
Valid Range: 0 to 7FFFFFFF Milliseconds
A built-in delay of 200 ms prevents motion detect from
detecting motion right after a successful decode. This allows
the barcode to be removed without triggering a new decode.
Use this register to add an additional delay amount to the
built-in delay.
Keywords: #MotionDetection