COE S7 - Page 31

Service
28
Trouble shooting
SHAKER HEAD LOSS OF POWER OR WILL NOT SHAKE
 CLAMPS BUT WILL NOT SHAKE
 BROKEN DRIVE BELT
 LOOSE BELT
 SLIPPING BELT
 LOW SYSTEM PRESSURE
 BAD ENERGY WHEEL BEARINGS
 NOT FULLY CLAMPED ON TREE
 LOW HYDRAULIC FLUID LEVEL
 SHAKE LOCK VALVE NOT LOCKING
 LEAKING HOSES OR CONNECTORS
 LOW SEQUENCE PRESSRE
 BAD SHAKER HEAD MOTOR
 SPOOL VALVE NOT SHIFTING FULLY
 CHECK SEQUENCE VALVE
 REPLACE BELT
 REPLACE OR PROPERLY ADJUST BELT
 CHECK FOR BAD MOTOR SHAFT SEAL.
CLEAN AND REPAIR
 ADJUST OIL PRESSURE
 REPLACE BEARINGS
 ADJUST CLAMP PRESSURE
 FILL TO PROPER LEVEL
 CHECK FOR DEBRIS REPLACE IF
NECESSARY
 REPAIR HOSE OR CONNECTIONS
 ADJUST TO PROPER PRESSURE
 REPAIR OR REPLACE MOTOR
 CHECK SPOOL VALVE FOR DEBRIS
SHAKER HEAD RATTLES OR MAKES KNOCKING SOUNDS
 LOW CLAMP PRESSURE
 LOOSE WEIGHT BOLTS
 SHAKER PAD MISSING
 OLD OR BROKEN SHAKER PAD
 BAD SEALS IN CLAMP CYLINDER
 OVER SPEEDING SHAKER HEAD
 WORN OR MISSING SUSPENSION
MOUNTS
 WORN CLAMP CYLINDER BUSHINGS
 WORN CLAMP CYLINDER PINS
 CLAMP ARM PIN WORN OR LOOSE
 WORN CLAMP ARM GUIDE PLATES
 DEFECTIVE LOCK VALVE
 ADJUST TO PROPER PRESSURE
 RE-TORQUE WEIGHT BOLTS
 INSTALL SHAKER PAD
 REPLACE SHAKER PAD
 REPLACE SEALS IN CYLINDER
 REDUCE SHAKER HEAD SPEED
 REPLACE WITH NEW SUSPENSION
MOUNTS
 REPAIR BUSHINGS OR REPLACE CYL
 REPLACE CLAMP CYLINDER PINS
 REPLACE ,REPAIR OR ADJUST
 REPLACE WEAR PLATES
 REPLACE LOCK VALVE CARTRIDGE
SHAKER PAD OR SLING FAILURE
 LOW CLAMP PRESSURE
 HIGH CLAMP PRESSURE
 WATER SYSTEM NOT WORKING
 RUNNING INTO TREES
 NOT USING SILICONE SOLUTION
 NOT USING PROPER GRADE MATERIAL
 INCREASE CLAMP PRESSURE
 REDUCE CLAMP PRESSURE
 REPAIR WATER SYSTEM
 DO NOT RUN INTO TREES
 USE SILICONE SOLUTION
 USE RECOMMENDED MATERIAL
Call Service department for tech support or service call