COE S7 - Page 32

Service
29
Trouble Shooting Trouble shooting
TREE BARKING OCCURING
 WATER SYSTEM NOT WORKING
 NOT USING SILICONE SOLUTION
 IMPROPER CLAMPING PRESSURE
 MISSING SHAKER PAD
 BAD CLAMP CYLINDER SEALS
 TREES RECENTLY IRRIGATED
 HEAD NOT CENTERED ON TREE TRUNK
 BAD LOCK VALVE CARTRIDGE
 HOLE WORN IN SLIP SLING
 REPAIR WATER SYSTEM
 USE SILICONE SOLUTION
 ADJUST CLAMP PRESSURE
 INSTALL SHAKER PAD
 REPAIR CLAMP CYLINDER SEALS
 SHAKE ONLY 2 WEEKS AFTER LAST
IRRIGATION
 CENTER CLAMP JAWS ON TREE TRUNK
 REPLACE LOCK VALVE CARTRIDGE
 REPLACE SLIP SLING
GROUND POWER WILL NOT WORK
 MACHINE LOW OR OUT OF OIL
 CHARGE FILTER PLUGGED
 LOW CHARGE PRESURE
 GROOVE ON PUMP VALVE PLATE
 GROOVE ON MOTOR VALVE PLATE
 REMOTE PEDAL NOT FUNCTIONING
 BAD PUMP RELIEF VALVE
 MOTOR/PLANETARY COUPLER IN-
STALLED INCORRECTLY
 SHEARED MOTOR SHAFT
 FAILED PLANETARY HUB
 ENGINE/PUMP COUPLER FAILURE
 PUMP SHAFT SHEARED/STRIPPED
 FILL TO PROPER LEVEL
 REPLACE CHARGE FILTER
 ADJUST PRESSURE OR REPAIR PUMP
 REPLACE VAVLE PLATE
 REPLACE VALVE PLATE
 REPAIR REMOTE PEDAL
 REPAIR OR REPLACE RELIF VALVE
 INSTALL COUPLER CORRECTLY
 REPAIR MOTOR SHAFT
 REPAIR PLANETARY FAILURE
 REPLACE ENGINE/PUMP COUPLER
 REPAIR PUMP SHAFT
MAIN PUMP NOT WORKING
 OIL LEVEL LOW
 IMPROPER OIL VISCOSITY
 COLD WEATHER
 PUMP SHAFT SHEARED/STRIPPED
 PUMP WORN OUT
 PINCHED/RESTRICTED SUCTION LINE
 BLOWN HYDRAULIC LINE
 LOOSE ADAPTER
 ADD OIL TO HYDRAULIC RESERVOIR
 DRAIN AND REPLACE WITH PROPER OIL
 WARM HYDRAULIC CIRCUIT
 REPAIR PUMP SHAFT
 REPAIR PUMP
 REPLACE SUCTION LINE
 REPLACE HYDRAULIC LINE
 RE-TORQUE ADAPTER
Call Service department for tech support or service call