COFFEtek VITRO S2 Series User Manual

VITRO S2/3
Revision 1
28/02/2017
54
DAILY HYGIENE
Cleaning Instant Units
This process should be carried out a minimum of three times a day.
 Set the On/Off switch on the machine to ON.
 Remove the instant ingredient canisters. Wipe clean the exterior surfaces of the canister
assembly. Wipe dry.
 Remove the coffee grouts bucket. Empty the contents of the bucket and wash and dry it.
 Remove the waste tray and grille. Empty the contents of the tray and wash and dry the tray
and grille.
 Put a container of at least 300ml capacity under the dispensing nozzles.
 Press the FLUSH button once on the internal keypad. The screen will ask if you wish to
flush the system. Press ENTER for YES
 The machine will run warm clean water through the instant bowl whilst running the whipper
motor. This process will clean any residual product that has been left in any of the systems.
Once again remove the coffee grouts bucket. Empty the contents of the bucket and wash
and dry it then refit into the machine.
Note: Some of these operations should only be performed in machines that incorporate tea
or coffee brewers. If your machine doesn't incorporate these elements, perform the next
step.
Cleaning The Coffee Brewer
 Set the On/Off switch on the machine to OFF and isolate the mains electrical supply from
the machine. Unlock and open the cabinet door.
 Remove the ingredient canisters. Wipe clean the exterior surfaces of the canister assembly.
Wipe dry.
 Remove the waste tray and grille. Empty the contents of the tray and wash and dry the tray
and grille.
 Remove the coffee grouts bucket. Empty the contents of the bucket and wash and dry it.
 Disconnect the tube connecting the coffee brewer to
the mixing bowl by pulling the black right-angled fitting
(A) away from the brewer itself. Remove the coffee
brewer safety cover and lift the lower carriage locking
lever (B) to the vertical, (unlocked position). Remove
the carriage assembly by pulling it gently towards the
front of the machine.
 Disconnect the ball and socket coupling visible inside
the coffee brewer extract chamber. This is accomplished by pulling the lower vertical rod
towards the front of the machine.
A
N
a
B
N
a
t

COFFEtek VITRO S2 Series Specifications

General

Brand	COFFEtek
Model	VITRO S2 Series
Category	Coffee Maker
Language	English