3
TABLE OF CONTENTS
®
Introduction ......................................................................................... pag. 5
Chapter 1................................................................................................. pag. 7
1. Aeterna Change-Giver Coin Mechanism rel. 2.7.......................................... pag. 7
1.1. Composition ................................................................................. pag. 7
1.2. Technical Specifications .................................................................. pag. 8
1.2.1. Specifications of the Coin Mechanism ............................................ pag. 8
1.3. Parts description ........................................................................... pag. 9
1.3.1. Aeterna Change-Giver Coin Mechanism .......................................... pag. 9
1.3.2. Aeterna Coin Mechanism with side cash-box .................................... pag. 10
1.3.3. Label for Coin Mechanism configuration ......................................... pag. 10
1.3.4. Base board ............................................................................ pag. 11
1.3.5. Validator/Separator Group ......................................................... pag. 12
1.3.5.1. Keypad and display ............................................................ pag. 13
1.3.5.2. IR Label.......................................................................... pag. 13
1.3.6. Tube Group ........................................................................... pag. 13
1.3.6.1. Tube box ........................................................................ pag. 14
1.3.6.2. Accumulation tubes ........................................................... pag. 14
1.3.6.3. Elastic forks .................................................................... pag. 14
1.3.7. Ejection Group ....................................................................... pag. 14
1.3.8. Technical data label................................................................. pag. 15
1.4. Accessories available on request ........................................................ pag. 15
1.4.1. Interface for electromechanical Automatic Vending Machine ................ pag. 15
1.4.2. MDB Cashless System ................................................................ pag. 16
1.4.3. MDB Bill Validator.................................................................... pag. 16
1.4.4. Recharge Key ......................................................................... pag. 16
1.4.5. EXE-RS232 Interface for Systems and Change-giver ............................ pag. 16
1.4.6. Accessories for programming and updating...................................... pag. 17
1.4.6.1. Maxi Programmer .............................................................. pag. 17
1.4.6.2. PC programming interface for systems/validators ....................... pag. 17
1.4.7. Accessories for data recording..................................................... pag. 18
1.4.7.1. Integrated IR interface ....................................................... pag. 18
1.4.7.2. Harness for serial communication to PC ................................... pag. 18
1.4.7.3. IR PORT Module ................................................................ pag. 18
1.4.7.4. Comunica Module .............................................................. pag. 18
1.4.7.5. Harness for printer ............................................................ pag. 19
1.5. General Operation ......................................................................... pag. 19
1.5.1. Coin reading .......................................................................... pag. 19
1.5.2. Operation conditions ................................................................ pag. 20
Chapter 2................................................................................................. pag. 21
2. Installation and connections ................................................................. pag. 21
2.1. Installation .................................................................................. pag. 21
2.1.1. Position of the Coin Mechanism ................................................... pag. 21
2.1.2. Fastening holes of the Coin Mechanism .......................................... pag. 21
2.1.3. Installation modes ................................................................... pag. 22
2.1.4. Configuration of the tube box ..................................................... pag. 23
2.1.4.1. Mechanical parts associated with the Euro coins ......................... pag. 24
2.1.5. Checks before starting .............................................................. pag. 24
2.1.6. First loading........................................................................... pag. 25
Table of Contents
To Next Page
Loading...