61
PROGRAMMING
®
mechanism tube, without dimming the lower photocell. The value is already programmed
inside the model and cannot be changed.
13.1-60.15 Maximum Photocell
The menu item displays the maximum number of coins which can be inserted inside the Coin
mechanism tube, without dimming the upper photocell. The value is already programmed
inside the model and cannot be changed.
13.1-60.16 Description
In this menu item are displayed the data programmed in the model and concerning the
different coins. In the lower line of the display is shown the alphabetic code of the
programmed currency, the coin value and the channel where it was stored.
13.61 Coin Read
It displays the parameters read which concern the last coin inserted in the Coin Mechanism.
The display shows the same parameters described at “13.1-60.1 Sent Values” item.
13.62 Validator Step
In this menu item is displayed the measure according to which the values of the coins are
calculated. With the Step at 1 (0.01), the Validator will calculate the coin value from 0.50 Euro
as 50 Step. The value is already programmed inside the model and cannot be changed.
14 Default [Operator (), Technician ()]
This menu item, by means of the code 6203, permits to reinitialize the Coin Mechanism. With this
operation the accounting data (partial and accumulated totals stored inside menu 3) are reset and
all the programming codes assume the default values (59.99 for prices).
The values of the model before the operation remain unchanged. As a default the data set is 0000.
To Next Page
Loading...