What to do if my Cola PETIT Stove shows 'AL 6 NO PELLETS'?
If the Cola Stove displays an 'AL 6 NO PELLETS' error, start by checking if the pellet hopper is empty. Also, the pellet feed gearmotor may need adjustment, or it may not be feeding pellets correctly. Adjust the pellet flow.
Why is my Cola PETIT Stove showing 'AL 3 HOT FUMES'?
If your Cola Stove is displaying an 'AL 3 HOT FUMES' error, it could be due to a faulty tangential fan, no power to the tangential fan, or too many pellets. Try adjusting the pellet flow to resolve the issue.
What does 'AL 7 THERMAL SAF' mean on my Cola PETIT Stove, and how do I fix it?
If your Cola Stove displays 'AL 7 THERMAL SAF', it means the safety thermostat detected a temperature above the setting threshold, likely due to overheating in the hopper's bottom part or the heating chamber water, which is blocking gearmotor operation. Check for the cause of excessive overheating and reset the safety thermostat by pressing the reset button.
What to do if my Cola PETIT displays 'AL 1 POWER FAILURE'?
If your Cola Stove shows 'AL 1 POWER FAILURE', it indicates no power during the lighting stage. Turn the stove OFF by pressing the button P4 and repeat the lighting procedure.
What causes 'AL 4 FAN FAIL' on my Cola PETIT Stove?
If your Cola Stove displays 'AL 4 FAN FAIL', it means that the fume fan is blocked, there is a faulty speed control sensor, or there is no power to fume fan.
What does 'AL 2 FUME PROBE' mean on my Cola Stove?
If your Cola Stove displays 'AL 2 FUME PROBE', it indicates a faulty probe or that the probe is disconnected from the board.
Essential safety guidelines for operating the stove.
Information on allowed usage and the correct type of fuel to use.
Guidelines for selecting a safe installation location and fire prevention.
Instructions for making the correct electrical connections.
Guidance on connecting the stove to the heating and water systems.
Specifies minimum distances from flammable materials to prevent fire.
Safety aspects related to the fume exhaust system.
Safety mechanisms for overpressure in the combustion chamber.
Information on overheating safety thermostats and their function.
Safety measures to prevent flare-back in the pellet chute.
Protection against overcurrent in the electrical system.
Safety measures for overpressure in the water circuit.
Safety procedures in case of fume fan failure.
Step-by-step guide for lighting the stove.
How alarms are indicated and managed by the stove.
General| Product color | Ivory |
|---|---|
| Hopper capacity | 21.5 kg |
| Housing material | Cast iron, Steel |
| Appliance placement | Freestanding |
| Fuel type | Pellet |
| Efficiency | 91.69 % |
| Flue draught (max) | 14 Pa |
| Flue draught (min) | 10 Pa |
| Pellet consumption (max) | 2.64 kg/h |
| Pellet consumption (min) | 0.78 kg/h |
| Minimum safety distance (rear) | 200 mm |
| Suitable for room volume up to | 294 m³ |
| Minimum safety distance (floor) | 0 mm |
| Power source | AC |
| AC input voltage | 230 V |
| AC input frequency | 50 Hz |
| Power consumption (typical) | 85 W |
| Power consumption (ignition) | 400 W |
| Hob included | No |
Weight and Dimensions| Depth | 622 mm |
|---|---|
| Width | 530 mm |
| Height | 1000 mm |
| Weight | 155000 g |
| Exhaust connection diameter | 80 mm |
To Next Page