Cold Jet i3 MICROCLEAN 2 - Setting Up the i³ MicroClean 2; Initial Setup Steps

21
Setting Up the i
3
MicroClean 2
WARNING Improper installation of hoses and adapters to the MicroClean 2 can cause
damage to the machine or the applicators.
Do not use one wrench when tightening or replacing ttings on the MicroClean 2 machine or the
applicators.
Always use two wrenches to install and remove hoses and accessories on the MicroClean 2 or the
applicators.
CAUTION When attaching the blast hose, make sure to put a ½ inch wrench on the SST
base connection of the rotary union. DO NOT rely on the polymer housing to
keep it from rotating. Any connections that are frozen should be thawed by
running air only through the applicator if machine has been in operation.
Follow the instructions below to set up the MicroClean 2:
1. Set the castor locks by pressing down (lift to release).
2. Attach the blast hose and control cable to the MicroClean 2.
3. Attach an applicator to the blast hose and control cable using two wrenches.