Cold Jet i3 MICROCLEAN - Pusher Plate; Compressed Air Nozzle; Troubleshooting

24
24
OM.MC.20160506
APPENDIX B:
PELLET & NUGGET SHAVING
air nozzle used to clear trough area
newly designed pusher plate for
pellets and nuggets
PUSHER PLATE
A unique pusher plate provides more
surface area to ensure consistent pellet and
nugget media feeding.
• The pusher plate is designed to work
optimally with pellets and nuggets. If using
blocks, a 6x6 in. (150x150 mm) block is
recommended. Blocks smaller than 5x5 in.
(125x125 mm) will not feed effectively in the
i
3
MicroClean.
COMPRESSED AIR NOZZLE
As moisture in the environment around the
i
3
MicroClean increases, condensation will
develop inside the trough. If this moisture
is not eliminated, dry ice media can begin
sticking and cause feeding issues.
PROBLEM CHECK THIS SOLUTION
Dry ice
output has
noticeably
decreased
PROBLEM CHECK THIS SOLUTION
Dry ice
output has
noticeably
decreased
air nozzle used to clear trough area pusher plate at center of trough
before filling
TROUBLESHOOTING