Cole Parmer Masterflex B/T Rapid-Load User Manual

Adjust flow rate with adjustment knob on top of regulator. Vary flow rate
from 20 psig to 100 psig. At higher pressures, the pump speed may exceed
321 rpm.
CAUTION: Do not exceed 321 rpm. Speeds in excess of 321 rpm
may cause damage to unit.
(Lock flow rate by using snap-action push-pull knob on filter regulator.)
For continuous-duty or high-speed application, use of the lubricator is
recommended. Adjust the lubricator with the adjustment knob on top. For
higher speeds, set lubricator to provide 1–3 drops/minute. Use a lower
setting for lower speeds. See below for RECOMMENDED LUBRICANTS.
(Lock lubrication rate by using snap-action push-pull knob.)
Figure 3-6. Model 77111-80
Use a misting type oil rated 50 to 200 SSU (ISO Grade 7 to 46) at 100°F
(38°C). Unscrew the bowl to fill the lubricator. Press up on the bottom
drain to empty bowl.
B/T
®
RAPID-LOAD
®
Peristaltic Pumps and Drive Operating Manual 3-9Cole-Parmer
Section 3
Operation
Model 77111-80
Recommended
Lubricants

Cole Parmer Masterflex B/T Rapid-Load Specifications

General

Brand	Cole Parmer
Model	Masterflex B/T Rapid-Load
Category	Water Pump
Language	English