Good Rubber Seal Damaged Rubber Seal
LP GAS CYLINDER RUBBER SEAL INSPECTION
DANGER
• NEVER store a spare LP cylinder, empty or full, under or near the
appliance.
• Never fill a cylinder beyond 80% full.
• An over filled or improperly stored cylinder is a hazard due to possible
gas release from the safety relief valve. This could cause an intense
fire or explosion with risk of property damage, serious injury or death.
• Do not store objects or materials inside the barbecue cabinet
enclosure that would block the flow of combustion air to the
underside of either the control panel or the burner box.
• If you see, smell or hear gas escaping, immediately get away from the
LP cylinder/appliance and call your fire department.
LP gas warnings:
• Always turn cylinder valve off when the barbecue is not in use.
• Always handle the tank valve with the utmost care.
• Never connect an unregulated LP gas cylinder to the barbecue.
• Always keep the cylinder, in use, securely fastened in an upright position.
• Never expose the cylinder to direct sunlight or excessive heat.
• Never insert any kind of object into the valve outlet as this may cause damage to the
Backcheck. A damaged Backcheck can leak resulting in fires, explosions, property damage,
severe injuries or death.
• Do not store an LP cylinder in enclosed spaces such as a carport, garage, porch, covered patio
or other building. Make sure the storage area has a lot of ventilation.
• Do not store an LP cylinder in an area where children play.
LP gas warnings:
• Inspect propane tank valve rubber seal
for cracks, wear or deterioration prior
to use. A damaged rubber seal can
cause a gas leak, possibly resulting in an
explosion, fire or severe bodily harm.
• Inspection should be done each time
propane tank is connected to barbecue,
has been refilled, exchanged or has not
been used for more than 60 days.
1. Check that the cylinder shut-
off valve is closed, by turning
knob clockwise.
2. Place cylinder into tank
holder in bottom of cabinet.
3. Orient cylinder so valve
opening faces forward.
4. Secure the tank using the
tank retention screw.
• Do not use a propane tank with a
damaged rubber seal. Exchange tank or
have rubber seal replaced at a qualified
propane filling station.
INSTALLING THE LP GAS CYLINDER
6
To Next Page
Loading...
