What to do if unwinder blocks on Collamat 9100?
If the unwinder blocks on the Collamat Label Maker: * Shift the disk on the unwinder shaft away from the disk brake if the disk touches the disk brake. * Lubricate the bearings on the shaft if the shaft is blocked. * Readjust the disk brake if the disk brake does not open.
Why does Collamat 9100 monitor frequently reset?
If the monitor frequently resets on your Collamat Label Maker: * Clear all programs using the password 4147 during the power-on procedure due to a software error. * Check the environment and wiring. All cables must be shielded in this case due to electromagnetic interference (EMI).
Why does adapter tilt down while labeling with Collamat 9100?
If the adapter tilts down while labeling with the Collamat Label Maker, thread the paper web correctly between the adapter roll pair, because the backing paper may not be threaded between the adapter roll pair.
Why does paperweb fall off in Collamat Label Maker?
If the paper web falls off in side labeling applications with the Collamat, mount the side labeling kit to the Collamat, because it may be missing.
Why is pressing roll axle bent down in Collamat 9100?
If the pressing roll axle hangs or is bent down on your Collamat Label Maker: * Retighten the hex nut (apply Locktite) if the fixing hex nut is loose. * Replace the axle if the pressing roll axle is bent or broken.
What to do if labels run through Collamat Label Maker?
If labels run through the Collamat Label Maker, several issues could be the cause: * A broken roll-up cable: replace the roll-up cable. * A broken label sensor cable: replace the label sensor cable. * A broken IR transmitter cable: replace the transmitter cable. * A broken IR transmitter LED: replace the transmitter print. * Labels sticking below the label sensor: remove the sensor and clean it properly. * A blind IR light guide: replace the IR light guide. * The label scanner position is not over the label: place the scanner over the label transport path.
What to do if 12V LED is off in Collamat 9100 Label Maker?
If the 12V LED is off on your Collamat Label Maker, check the peripheral units, as it is probably the result of a short of the 12V in the peripheral units.
What to do if 5V 12V and 24V LEDs are all off in Collamat Label Maker?
If the 5V, 12V, and 24V LEDs are all off on your Collamat Label Maker, check the peripheral units and replace the fuse (10AT), because Fuse F2 is blown, probably result of a short of the 24V in the peripheral units.
How to increase speed of Collamat 9100 Label Maker?
If Collamat labels only at 3m/min, change the monitor speed setting to meet the requirements, because it may be set to default FIXED SPEED.
Why Collamat 9100 Label Maker labels are not dispensed straight?
If labels are not dispensed straight forward from the Collamat Label Maker, replace the peeling bar, as it may be worn out.
General| Brand | Collamat |
|---|---|
| Model | 9100 |
| Category | Label Maker |
| Language | English |
To Next Page
