COLOP e-mark create - e-mark create app; How to setup the e-mark create; Printing at a glance

To Next Page

To Previous Page

e-mark

create app

How to setup

Printing at a glance

The e-mark

create can be used with the e-mark

create app

on phones and tablets with either Android 7.0 and iOS 11 or higher.

Download here getemarkcreateapp.colop.com

the e-mark

create

Select New Imprint in the app menu (by clicking on the 3 horizontal line icon top left)

Choose Start without template, either 1,2 or 3 lines, or select a pre-made template from your

preferred category

Arrange or change your artwork in the editor

Once your design is ready to go, select the e-mark

create icon in the top right corner

The e-mark

create will beep and the app will indicate when your print has been received

Simply swipe the device either to the left or right to print your design

A short beep indicates that the imprint is done

Assemble your e-mark

create according to the Quick Setup Guide, which you received along

with your device

Pay attention that the Wi-Fi on your phone or tablet is switched on

Install the e-mark

create app and open it

Select your preferred language and click next

Accept the Wi-Fi information and click continue

Now enter the SSID and password that came with your e-mark

create (to be found on

the Quick Setup Guide) and click connect

On iOS devices you will be asked to join the Wi-Fi connection the e-mark

create generates - click join

Attention:

Never connect to the Wi-Fi through your phone settings, always connect through the app.