26
WEEKLY MAINTENANCE
CLEANING THE SUCTION TUBE
Whenever suction seems to be unsatisfactory, check that the suction tube
is not obstructed. If necessary, clean it with a water jet introduced from the
side where it is connected to the tank. Proceed as follows:
1. remove the suction tube from the curved sleeve of the recovery tank
(1)
2. disconnect the clamp (2) and remove the suction tube from the
squeegee suction sleeve
3. clean the inside of the tube with a jet of water
5. reassemble everything, carrying out the above-mentioned operations
in the reverse order
CLEANING THE SOLUTION TANK AND FILTER
With the solution tank empty:
1. turn off the water tap
2. unscrew the filter and rinse the inside thoroughly
3. remove the cartridge and clean it
4. reassemble everything, repeating the above-mentioned operations in
the reverse order
5. turn on the water tap
Note: the filter can also be cleaned when the solution tank is full. Just
remember to turn off the tap
6. Loosen the upper cap
7. Rinse the tank with a water jet
1
To Next Page
Loading...
