IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
1. Open the archive in GenConfig and use the function File -> Generate Cfg
Image -> Comm. objects to create a list of all communication objects.
2. Open the file, find the row containing this value and look for the column
"Type". The column "Type" contains reference to a list of codes and their
representations located in the bottom part of the file.
Value: Breaker state
Code of the current state of the breaker control. The text representation of each
code can be obtained by the procedure described at the value Engine state.
Value: Timer text
Code of the currently running system process timer. The text representation of
each code can be obtained by the procedure described at the value Engine state.
Remaining time of the timer is available in the value Timer val.
Value: Timer val
The value contains remaining time of the currently running system process timer.
The name of the timer is available in the value Timer text.
Value: ECU DiagSource
This value indicates from which source the ECU diagnostic messages are beeing
received. The source depends on ECU type.
Value: NextTime1-4
This value contains time of next activation of the timer block 1-4 (i.e. of the output
To Next Page
Loading...
Need help?
General
