ComAp intelilite nt amf20 User Manual

InteliLite
NT
– AMF20/25, SW version 2.2, ©ComAp – September 2014 126
IL-NT-AMF-2.2-Reference Guide.pdf
Gen V L2-N
Gen V L3-N
Gen V L1-L2
Gen V L2-L3
Gen V L3-L1
Gen freq
Gen kWh
Gen kVArh
L1 kW
L2 kW
L3 kW
L1 kVArh
L2 kVArh
L3 kVArh
Pwr factor
Load char
Act power
Mains V L1-N
Mains V L2-N
Mains V L3-N
Mains V L1-L2
Mains V L2-L3
Mains V L3-L1
Mains freq
Mains kWh
Mains kVArh
Num starts
Run hours
Num items alarmlist
Item 1..16 alarmlist
Read / Write:
ControllerMode
Maintenance hours
Action argument
Write only:
User identification number
Password
Action command
To generate MIB table go to LiteEdit 4.6 or higher and use “Controller” -> “Generate Cfg image” ->
“Generate SNMP MIB table”
Hint:
Please refer to IB-Lite New features list for more information about SNMP support.
Firmware version 2.1 and lower
For SNMP protocol support it is possible to use converter Modbus RTU - SNMP with ComAp order
code “GNOME SNMP CONVERTER IL-NT”.
 For connection of 1-32 IL-NT controllers to a SNMP supervision system
 Supports GET, SET, TRAP transactions
For more details see IL-NT, IA-NT, IC-NT Communication Guide available here:
http://www.comap.cz/products/detail/intelilite-nt-amf-25/downloads/#tabs

ComAp intelilite nt amf20 Specifications

General

Brand	ComAp
Model	intelilite nt amf20
Category	Controller
Language	English