InteliLite 4 AMF20+AMF25 Operator Guide 3
FAULT RESET button. Use this button to acknowledge alarms and
deactivate the horn output. Inactive alarms will disappearimmediately
and status of active alarms will be changed to "confirmed" so they will
disappear as soon as theirreasons dismiss.
UP button. Use this button to move up orincrease value.
PAGE button. Use this button to switch overdisplay pages.
DOWN button. Use this button to move down ordecrease value.
ENTER button. Use this button to finish editing a setpoint ormoving right in
the history page.
START button. Works in MAN mode only. Press this button to initiate the
start sequence of the engine.
STOP button. Works in MAN mode only. Press this button to initiate the
stop sequence of the Gen-set. Repeated pressing of button will cancel
current phase of stop sequence (like cooling)and next phase will
continue.
GCB button. Works in MAN mode only. Press this button to open orclose
the GCB.
MCB button. Works in MAN mode only. Press this button to open orclose
the MCB.
GENERATOR status indicator. There are two states – Gen-set OK (indicatoris
green)and Gen-set failure (indicatoris red). Green LED is on if the generatorvoltage and
frequency is present and within limits. Red LED starts flashing when Gen-set failure
occurs. After FAULT RESET button is pressed, Red LED goes to steady light (if an
alarm is still active) oris off (if no alarm is active).
MAINS status indicator. There are two states – Mains OK (indicatoris green)and
Mains failure (indicatoris red). Green LED is on, if mains is present and within limits.
Red LED starts blinking when the mains failure is detected and afterthe Gen-set has
started and connected to the load it lights permanently until the mains failure
disappears.
Graphic B/W display, 132 × 64 px.
To Next Page
Loading...
