Operation
71
C3M2-OM-EN-02
Coolant is hazardous to the environment. Do not allow coolant to leak into the
environment. Clean up any spillage using binding material and dispose of it in
accordance with environmental regulations.
The coolant level is monitored via the transparent coolant bottle, mounted on the right
hand side of the operator’s cabin.
To Check/Top Up The Coolant Level:
1. Park the truck in accordance with the
recommended parking procedure.
2. Open the bonnet (A) from the rear of
the truck.
3. Look in at the coolant bottle (B). The
coolant level should be visible
between the low and full level marks.
4. If the coolant level is low it must be
topped up to half way between the low
and full level marks.
5. If the coolant is not visible in the bottle
the radiator must also be topped up.
6. The radiator cap must be cool enough
to touch before removing.
7. Turn the cap anticlockwise gradually to release any pressure before removing
fully.
8. Top up the coolant and replace the cap(s) securely. See section 6.11 ‘Engine
Cooling System’ on page 111 for coolant and water quality details.
B
A
To Next Page
Loading...
