10
You’ll need to scan for channels aer setting your antenna up. To do that:
1. Turn your TV on and press the home button on your remote
2. Select the Antenna tile, or open Settings > Antenna and inputs > Antenna
> Channel scan
3. Follow the on-screen instructions, then select Scan for channels
4. Wait while your TV scans for channels – this can take several minutes
5. When the channel scan is nished, you’ll see the number of channels that
were added
6. Click Continue
If you’re using an antenna with a twin-lead cable, you may need a 300-75 Ohm
adapter (not included) to be able to use your twin-lead cable with your TV. If you’re
using multiple antennas, you may also need a combiner (not included).
Connecting an HDMI device
To connect an HDMI device, plug one end of an HDMI cable (not included) into
1 of your TV’s 3 HDMI ports (see Table 1 below). Then plug the other end into your
device.
Connecting a device with a composite video cable
To connect to a device using a composite video cable, plug the red, white, and
yellow ends of the composite video cable (not included) into your TV’s AV IN port
(see Table 1). Then plug the other end into your device.
Connecting headphones
To connect headphones (not included) to your TV, plug them into your TV’s
HEADPHONE port (see Table 1). The sound from the built-in speakers of the TV will
be disabled when the headphones are connected.
To Next Page
Loading...