Section 1: The MicroBlaster MB1000 MicroBlaster MB1000
Comco Inc. 1-6 Issue Date: July 2016
Detail Specifications
Abrasive (see Section 3)
Type Selected powder, smooth to sharp, soft to hard
Size 20 to 300 Microns
Nozzles (see Section 3)
Material Highest quality Tungsten Carbide
Sizes, Round 0.015 to 0.060 in. Dia. (.381 to 1.524 mm)
Sizes, Rect. 0.008 x 0.020 to 0.012 x 0.150 in. (.203 x .508 to
.305 x 3.81 mm)
Configuration Straight or Right Angle
Air
Type Dry Compressed Air, Nitrogen, or CO
2
Supply Pressure 80 to 140 PSIG (5.5 to 9.65 Bars)
Volume, Max 2.4 SCFM (68 SLM)
Working Pressure 40 to 125 PSI (2.7 to 8.6 Bars)
Moisture 200 PPM Max
Oil 10 PPM Max
Particles 5 Microns Max
Electrical
Voltage
[*]
115 or 230 (+10, -20) VAC
Frequency 50/60 Hz
Power 40 Watts
Physical
Width 16.5 in. (42 cm)
Depth 10 in. (25.5 cm)
Height 9 in. (23 cm)
Weight 20.5 lbs. (9.3 kg)
Tank Volume 50 in
3
(820 cm
3
)
Tank Capacity, abrasive 2 lbs. (1 kg)
During normal operation, employing a 0.030" diameter nozzle, a 0.025" diameter tank
orifice, and 25 micron aluminum oxide powder; a full tank of powder (approximately 2
lbs.) will last about 4 hours of actual blast time; air will be used at about 60 standard
cubic feet per hour at 80 psig; and nozzle life will be 8 to 35 hours depending on the
amount of wear that can be tolerated.
[*]
Operating voltage specified by order and as shown on nameplate.
To Next Page
Loading...