20
C8.5 - Triple call on/o (available from R.I.006)
This is disabled by default.
This function can be used to activate or deactivate the triple
call made by the switchboard to the internal units.
The call will therefore take place on 3 consecutive occasions
(in the case of video calls: the first 2 will be audio calls and
the third will be a video call).
To activate the function:
1. press the MENU key and use the
keys to view the
8-ADVANCED OPTIONS menu, then press 8;
8-ADVANCED
OPTIONS
2. use the keys to display the 5-TRIPLE CALL ON/OFF
menu;
5-TRIPLE CALL
ON/OFF
3. press 5 to activate or deactivate the function;
SERVICE
ACTIVE
SERVICE
NON ACTIVE
C8.6 - Function CH-CH contact (available from R.I.006)
This function can be used to assign a function to the CH-CH
contact; by default the active function is call repetition and
it is possible to select a contact time (closure) of either 1, 3 or
5 seconds.
Alternatively, the parallel or external monitor function can
be activated; the contact will close for the entire duration of a
VIDEO call from the external unit.
To activate the function:
1. press the MENU key and use the
keys to view the
8-ADVANCED OPTIONS menu, then press 8;
8-ADVANCED
OPTIONS
2. use the keys to display the 6-FUNCTION CH-CH
CONTACT menu, then press 6;
6-FUNCTION
CH-CH CONTACT
3. press 1 for the CALL REPLY function or 2 for the
EXTERNAL MONITOR function;
1-CALL REPLY
2- EXT. MONITOR
» if key 1 has been selected, the CONTACT TIME (closure)
will be requested; use keys to display the selected
time (1, 3 or 5 sec.);
CONTACT TIME:
1 SEC
CONTACT TIME:
3 SEC
C8.7 - Function main cps+sec (available from R.I.006)
This is disabled by default.
CAUTION!
1. This function must remain disabled to prevent
malfunctioning when using switchboards, brackets,
door-entry phones, switching devices and mixers with R.I.
lower than the values indicated in the table below.
2. This function must be activated on all switchboards for
the correct operation of Simplebus TOP systems (with
switching devices Art. 1424) which use both main and
secondary switchboards.
To activate the function:
1. press the MENU key and use the
keys to view the
8-ADVANCED OPTIONS menu, then press 8;
8-ADVANCED
OPTIONS
2. use the keys to view the 7- FUNCTION MAIN
CPS+SEC menu;
7- FUNCTION
MAIN CPS + SEC
3. press 7 to activate or deactivate the function;
SERVICE
ACTIVE
SERVICE
NON ACTIVE
System performance and layouts
For further information of system performance and to view installation layouts, click on the system type that best meets your
requirements:
• SBTOP audio/video system for the creation of audio-video systems for residential complexes.
• SB1 audio system for the creation of audio systems for residential complexes.
To Next Page
Loading...