35
ORIGINAL INSTRUCTIONS
7 MAINTENANCE
7.1 General Information
On the basis of usage conditions it is necessary to define a proper inspection
procedure. Time and frequency for regular maintenance activities are indicated below
and give a general idea, but they could vary based on the real work requirements.
This manual does not provide detailed information on the dismounting procedure and
the extraordinary maintenance activities, because these operations must always be
performed by the customer service staff of Breaker S.r.l.
The Customer Service is able to provide all information and to respond to all requests
to treat and maintain the electric chain saws E21 - E23 as perfectly efficient as
possible..
In case of installation of non-original parts the guarantee loses validity!
7.2 Regular maintenance
Always disconnect the supply power plug
ALWAYS check that the electric saw plug is disconnected before going on
with the maintenance, the cleaning or the lubrication procedures,
otherwise serious injuries may follow.
General maintenance, overheating
The motor of the electric saw is designed so as not to become overheated
during normal use. A possible overheating can be caused by worn or badly
sharpened chain, inadequate chain lubrication, excessive pressure on the
electric saw while cutting or obstruction of the motor air slits.
If such an overheating should occur, stop using the electric saw immediately
and have it checked by an authorized service center.
To Next Page
Loading...
