9
ORIGINAL INSTRUCTIONS
7. Always use the electric saw wearing the appropriate Personal Protective
Equipment, such as: accident prevention and anti-slip shoes, gloves, visor for the
face or goggles, work overalls and ear muffs.
8. If the cut produces a lot of dust, use a dust mask as well.
9. Never wear scarves, bracelets, or any large pieces of clothing that may get caught
in the machine or the chain. Wear clothing that is snug-fitting, comfortable, and
resistant to cutting.
10. Never use your electric saw in explosive or inflammable atmospheres.
11. Never use the electric saw in case of low visibility. Always work in sufficiently
lighted areas.
12. Do not expose the electric saw to rain, bad weather or high humidity conditions.
13. Always carry the electric saw with the chain-cover on and the blade always facing
backward.
14. Never work with an electric saw that is damaged, incorrectly assembled or
randomly modified. Do not remove, damage, or make ineffective any of the guards
and safety devices.
15. Before performing maintenance, cleaning or lubrication activities on the electric
saw, always check that the electrical plug is disconnected from the mains.
16. Before each use, check that the electric saw works properly.
17. Do not start cutting until you are sure that the work area is completely free from
people or animals.
18. Do not allow anyone to remain in the range of operation of the electric saw while it
is running.
19. Always keep the grips clean and dry.
20. When the motor is running, always hold the front grip firmly with your left hand and
the rear grip with your right hand,
21. Always cut in a stable and safe position.
22. Never keep the electric saw above the height of your shoulders.
23. Always start cutting when the chain is moving. During work use the teeth as a
support point.
24. Never begin cutting with the point of the bar; always use extreme caution when
cutting walls, window frames or similar.
25. Always cut in such a way that the bar does not remain stuck in the material you are
cutting.
26. Carefully keep this manual and refer to it before each use of the tool.
27. Make sure that the voltage and frequency indicated on the plate correspond to
those of the supply line, and that the line complies with the regulations.
To Next Page
Loading...
