EasyManuals Logo

Comet KS Series User Manual

Comet KS Series
Go to English
124 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
25
. R M
Follow the instructions in the “Switching osection and abide by the recommendations in the table
below.
INTERVAL FOR MAINTENANCE ACTION
Each time used • Check the supply cable, high-pressure pipe, couplings, cleaner gun, lance pipe.
Should any of these parts appear to be damaged, do not use the high
pressure cleaner and contact a Skilled Technician.
Weekly • Clean the water inlet lter (15).
Usually, it is sucient to pass the lter under running water or in a jet of
compressed air to clean it. In more dicult cases, use a lime scale remover or
replace the lter. Contact an authorised service centre for the purchase of a
new lter.
Monthly • Clean the nozzle.
For cleaning, it is generally enough to pass the supplied pin (17) inside the
nozzle hole. In case you do not obtain any appreciable result, replace the nozzle
by using the supplied wrench (16). For purchasing the spare part, apply to an
authorised service centre.
CAUTION
During use, the high pressure cleaner should not be too noisy and large amounts of water or oil should
not drip from underneath it.
In this event, a Skilled Technician should test the appliance.
. S M
WARNING
• Only Skilled Technicians are authorised to carry out special maintenance.
Follow the instructions in the table below for special maintenance.
INTERVAL FOR MAINTENANCE ACTION
Every 100 hours Check the pump hydraulic circuit.
Check the pump xing.
Every 200 hours Replace the pump oil.
Check the pump suction/delivery valves.
Check the pump screws are tightened.
Check the pump adjustment valve.
Check the safety devices.
CAUTION
• e data in the table are indications.
D A D
Only trained personnel are allowed to dismantle the high pressure cleaner in accordance with the current
regulations in the country where it is installed.
In particular, the symbol
on the identication plate (18) indicates the product must not be disposed
of together with normal household waste.
For further information, contact your local authority’s waste disposal service or your local retailer.
WARNING
Before disposing of the high pressure cleaner, make sure it is no longer possible to operate it, by cutting the
power supply cable for example. Make sure all its parts are inoensive, as they could prove to dangerous
to children playing.
EN

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Comet KS Series and is the answer not in the manual?

Comet KS Series Specifications

General IconGeneral
BrandComet
ModelKS Series
CategoryPressure Washer
LanguageEnglish

Related product manuals