27
1. Water inlet connector
2. Main switch
3. Hose reel ring nut (only EXTRA)
4. Hose reel (only EXTRA)
5. Hose reel knob (only EXTRA)
6. Water outlet connector (only CLASSIC)
7. High pressure hose
8. Accessory tray
9. Seat for water gun/lance hose
10. Plate “Read the manual before...”
11. Object-holding pocket
12. Identication plate
13. Plate “Do not spray towards persons,...”
14. Power supply wire
15. Plate “Guaranteed sound power ”
16. Water gun
17. Lance hose
18. Nozzle-holding head
19. Nozzle cleaning hole
20. Nozzle
21. Lance stand
22. High-pressure hose fast connector (only CLASSIC)
23. Pocket for accessories (only CLASSIC)
24. Water gun lever
25. Water gun lever safety stop
26. Handle
27. Water adjusting knob
28. Stack
29. Plate “Caution: Hot surfaces”
30. Pressure gauge
31. Detergent tank plug
32. Gas oil tank plug
33. Water suction lter/gasket
34. Control panel
35. Water suction connector
2.2 SAFETY DEVICES
This water cleaner is provided with the following safety devices:
a) Amperometric protector
It is a device that is built in the switch (2) that stops the water cleaner operation in case of current
over-absorption, thus making the switch itself trigger to position “0”.
When it triggers, it is necessary to proceed as follows:
- remove the plug from the power socket;
- press the lever (24) of the water gun, in order to evacuate the possible rest pressure;
- wait 10÷15minutes, so that the water cleaner cools down;
- check the prescriptions described in paragraph “CHECKS AND CONNECTION TO THE MAINS
ELECTRICITY SUPPLY
”, with special reference to the check of the possibly used extension;
- reconnect the plug into the power socket and repeat the starting procedure described in paragraph
“OPERATION”.
b) Safety valve
It is a maximum pressure valve that is duly calibrated by the Producer and that discharges the
pressure in excess, in case of failure to the pressure and/or temperature adjusting system.
« CAUTION
• If this safety device cuts in repeatedly, do not use the water cleaner until it has been checked
by a Skilled Technician.
c) Pressure limiting/adjusting valve
It is a valve that is duly calibrated by the Producer and that avoids the generation of pressures
that are higher than the maximum allowed ones, thus making the uid in excess ow back to the
pump suction.
d) Temperature limiting/adjusting thermostat
It is a device that avoids to overcome the maximum temperature.
e) Water missing protection
It is a device that prevents the burner from operating in case of water absence.
To Next Page
Loading...
Need help?
General
