Comet SCOUT 150 User Manual

34
35
5.4 USE WITH DETERGENTS
« CAUTION
• The high pressure cleaner was designed to be used with the detergents recommended by the
Manufacturer. Use of other detergents or chemicals can affect the safety of the high pressure
cleaner.
Never suck up liquids, which contain solvents, petrol, diluents, acetone and fuel oil, as these
products are highly inammable, explosive and toxic when nebulized.
• Carefully read the instructions and warnings on the label of the detergent to be used.
• Store detergents in a safe place out of children’s reach.
• Should detergent come into contact with your eyes, wash immediately with water. Contact a
doctor without delay and remember to take the container of detergent with you.
• If detergent is swallowed, do not provoke vomiting. Contact a doctor without delay and
remember to take the container of detergent with you.
• When lling the tank with detergent, take care not to spill any detergent on the high pressure
cleaner. If this should happen, wait at least 24 hours before using the high pressure cleaner
so that any liquid, which may have entered the appliance, can evaporate.
The recommended detergents, are over 90% biodegradable.
• Remove the plug (31) and by paying attention not to make the uid overow (we recommend to
use a funnel only for this operation), ll the tank (max. capacity of 4.5 l/1.2 US gal) by following
the recommendations relating to the batching that are reported on the detergent packaging; close
the tank.
WARNING
• During the lling/topping-up operations of the gas oil tank, pay attention not to confuse the
tanks. If you pour detergent into the gas oil tank by mistake, do not use the water cleaner and
apply to a Skilled Technician.
• As for the use mode, refer to the indications on the detergent packaging.
• Rotate the ring nut of the nozzle-holding head (18) as shown in Fig. 1-a and then activate the
lever (24) of the water gun and start to spray the detergent. Rotate the nozzle-holding ring nut
(18) as shown in Fig. 2-b to reset the high-pressure operation.
5.5 INTERRUPTING USE (TOTAL STOP)
Release the lever (24) on the cleaner gun and the water cleaner will automatically stop.
The water cleaner starts operating normally again when the lever on the cleaner gun is pressed
again.
« CAUTION
• It is important to remember that the high pressure cleaner is still operational when it is in Total
Stop mode. Therefore, always put the main switch (2) in position “0”, remove the plug from
the power outlet, press the lever (24) on the cleaner gun to eliminate any remaining pressure
and lock the safety protection device (25) (Fig. 1, position S), before leaving it unattended,
even for a short time.
6 SWITCHING OFF AND STORAGE
After cleaning, switch the water cleaner off and prepare it for storage.
6.1 SWITCHING OFF
• Use the water cleaner with cold water for a couple of minutes.

Comet SCOUT 150 Specifications

General

Brand	Comet
Model	SCOUT 150
Category	Pressure Washer
Language	English