Comet SCOUT 150 User Manual

36
37
INTERVAL FOR MAINTENANCE ACTION
Each time used Check the supply cable, high-pressure pipe, couplings, cleaner gun, lance pipe.
Should any of these parts appear to be damaged, do not use the high
pressure cleaner and contact a Skilled Technician.
Weekly Cleaning the water suction lter/gasket (33).
Usually, it is sufcient to pass the lter under running water or in a jet of
compressed air to clean it. In more difcult cases, use a lime scale remover
or replace the lter. Contact an authorised service centre for the purchase
of a new lter.
The inner water inlet lter must be cleaned by a Skilled Technician (see also
paragraph “Special maintenance”).
Monthly Clean the nozzle (20).
For cleaning, it is generally enough to pass the supplied pin (19) inside
the nozzle hole. If you do not obtain suitable results, replace the nozzle by
applying to an authorised service centre to buy the spare part. To replace it,
use a 14-mm socket wrench (not supplied).
WARNING
• During use, the high pressure cleaner should not be too noisy and large amounts of water or
oil should not drip from underneath it.
In this event, a Skilled Technician should test the appliance.
7.2 SPECIAL MAINTENANCE
« CAUTION
• Only Skilled Technicians are authorised to carry out special maintenance.
Follow the instructions in the table below for special maintenance.
INTERVAL FOR MAINTENANCE ACTION
Every 100 hours Check the pump hydraulic circuit.
Check the pump xing.
Ad just the electrodes.
Clean the gas oil nozzle.
Check/replace the gas oil lter.
Check/replace the inner water inlet lter.
Every 200 hours Replace the pump oil.
Check the pump suction/delivery valves.
Check the pump screws are tightened.
Check the pump adjustment valve.
Check the safety devices.
Every 500 hours Replace the electrodes.
Replace the gas oil nozzle.
Clean the boiler.
Descale the coil.
WARNING
• The data in the table are indications.
8 DISMANTLING AND DISPOSAL
Only trained personnel are allowed to dismantle the high pressure cleaner in accordance with the
current regulations in the country where it is installed.
« CAUTION
• Before disposing of the high pressure cleaner, make sure it is no longer possible to operate it,
by cutting the power supply cable for example. Make sure all its parts are inoffensive, as they
could prove to dangerous to children playing.

Comet SCOUT 150 Specifications

General

Brand	Comet
Model	SCOUT 150
Category	Pressure Washer
Language	English