13
REMOVING THE COLLECTED WATER
There are two ways to remove collected water.
Bucket drainage
Type 1: Type 2:
water hose drainage
(continuous)
Type 1: Use the bucket
· When the unit is o,if the bucket is full, the unit will beep 8 times(on some models) and the Full Water
indicator light will flash.
· (For some models)When the unit is on,if the bucket is full, the compressor turns o and the fan turns o
after 30 seconds for drying the water of the condenser , then the unit will beep 8 times and the Full Water
indicator light will flash.
· Slowly pull out the bucket. Grip the left and right handles securely , and carefully pull out straight so
water does not spill. Do not put the bucket on the floor because the bottom of the bucket is uneven.
Otherwise the bucket will fall and cause the water to spill.
· Throw away the water from the water outlet and replace the bucket. The bucket must be in place and
securely seated for the dehumidifier to operate.
· The machine will re-start when the bucket is restored in its correct position.
Step 1 :
Pull out the bucket
a little.
Step 2 :
Hold both sides of the
bucket with even strength,
and pull it out from the unit.
Step 3 :
Pour the water out.
EN
To Next Page
Loading...
