Comfort MINI - Upholstery Cleaning; Removing and Putting on the Wheels

11
UPHOLSTERY CLEANING
UPHOLSTERY MADE OF FABRICS TYPE "Microphase"
For cleaning upholstery made of suede-like fabrics, use a soft clothing brush with natural bristles or
a vacuum cleaner with a delicate nozzle. Dirt can be removed with warm water and mild soap.
Moisten the dirty place with soap previously applied to a towel or sponge and remove stains with
little pressure in a circular motion. Leave the moistened places to dry naturally (do not use a dryer).
If necessary, repeat the cleaning process. Brush the dried place according to the structure of the
fabric. Strong dirt and stains can be removed with water-based agents or foams for cleaning carpets
and upholstery materials.
UPHOLSTERY MADE OF IMPREGNATED FABRICS
To clean upholstery from impregnated fabrics, use a soaped brush or sponge and warm water.
The elastic filling of the upholstery is made of polyurethane foam, which under the influence of
moisture and other weather conditions does not change its properties.
Remark:
• it is not allowed to wash the upholstery in washing machines, or manually by immersion.
• it is forbidden to use cleaning agents such as: turpentine, kerosene, solvent, chloroethylene.
The use of improper cleaning agents and non-compliance with the above-mentioned cleaning method
may cause permanent damage to the fabric, which cannot be the basis for a complaint.
REMOVING AND PUTTING ON WHEELS
Before removing the wheel, first press the clamp in the wheel cap and if the stroller is equipped
with hubcaps wound on the axles, they must be unscrewed beforehand.
After mounting the wheels equipped with a latching mechanism, attention should be paid to the
correctness of the mechanism. In the case of wheel caps wound on axles, special attention should be
paid to the correct position of the cap relative to the axle and the tightening force. Caps should be
tightened manually to a perceptible resistance without the use of any tools.
Remark:
In strollers with front swivel wheels, dismantling and assembling the wheels requires
the use of tools ( Allen wrench "6").