12
TIRE INFLATION
In order to inflate the tires, use the pump supplied with the stroller or other available pump (manual
or foot) to the valves in which the wheels of the stroller are equipped. Absolutely do not exceed 200
Kpa (0.2 MPa) – recommended pressure 180 Kpa (0.18 MPa).
Remark:
Inattentive (too strong) inflating of tires can be very dangerous. To avoid a breakage or even
explosion of the inflatable tire, a pressure gauge (e.g. a car pressure gauge) should be used when
checking the pressure, and in the absence of a pressure gauge, the pressure should be controlled
by the tire button with your fingers.
Fig. 4
in the stroller loaded with the user, the tires in the place of their adhesion to the ground should
gently bend, so that a slight bulge appears on the side of the tire.
ADJUSTMENT AND MAINTENANCE
In order to keep the stroller in proper technical condition, the following steps should be carried
out once a month or more often if necessary (e.g., during intensive use):
1. Adjust the mechanism that determines the position of
the backrest.| In case of poor operation of the clamp, you
should:
• release (by lowering downwards) the eccentric clamp
lever located on the right side of the stroller – see Figure 1
• tighten the nut located on the opposite side of the stroller –
see Fig. 5, and then tighten the lever (lift upwards) – see Fig. 1
Remark:
When tightening the nut, use your fingers or
for ease with pliers.
Fig. 5
With a properly inflated tire: the thumb pressing on the
side of the tire must sink a few millimeters into it – see
Figure 4
To Next Page
Loading...