Page 11 Vers. 1.0
Operation Instruction:
1. “ShowMe” Button.
DaisyNET-TX has two statuses: HDBT Pass-through and Local Input.
At HDBT Pass-through status DaisyNET-TX is used as a HDBT Extender (All input
led indicators go out at this status).
Press “ShowMe” button to change to Local Input status.
At Local Input status DaisyNET-TX is used as a 3-Input Switcher.
Press “ShowMe” button to select input port.
To change back to HDBT Pass-through status you must press “ShowMe” button for
more than 3 seconds.
※“ShowMe” button also has an operation-cancel function.
For example: several DaisyNET-TXs are connected together, there is always one
DaisyNET-TX working at Local Input status and others working at HDBT
Pass-through status.
If you mistakenly press “ShowMe” button of a DaisyNET-TX working at HDBT
Pass-through status, the very DaisyNET-TX worked at Local Input status before will
change to HDBT Pass-through status.
To cancel this operation mistake, press “ShowMe” button for more than 3 seconds,
and all DaisyNET-TXs will recover their statuses before the press action.
2. RS232 Control.
For the command set please ask your certified dealer.
To Next Page
