MT Series DryLine
®
Dehydrator User Manual
11
System may not be properly sized.
Or
Leaks may exist. Check using Snoop or
detergent water.
Or
Normal connector leakage may be greater
than expected.
During the off cycle, the dehydrator is designed
to allow a small amount of system air to bleed
back through the membrane dryer. This air
maintains the dryness of the membrane dryer.
As system air bleeds back through the dryer,
additional system moisture is continually
removed, lowering the system dew point even
further.
Thefrontpanelgaugeshouldreectthesystem
pressure.
Your system is now up and running at the factory
programmed settings.
Connect the alarm wiring to the terminals on
the inside of the unit. Refer to the label on the
alarm board or the schematic for the proper
connections.
To Next Page
Loading...
Need help?
General