CommScope DryLine MT Series User Manual

MT Series DryLine
®
Dehydrator User Manual
19
Section 6
In Case of Difculty
Ifyouexperiencedifcultywithyourdehydrator,
use the troubleshooting procedures described
on the next page. Perform the tests, inspections
and corrective actions corresponding to the
problem in the order listed. See System
congurationdiagramBasicorSystem
congurationdiagramMulti-Lineforpiping
connections and Door Schematic or Chassis
Schematic for wiring. Section 7 lists replaceable
parts.
CommScope Technical Service. If you cannot
correct the problem or if there are other
difculties,contacttheCommScopeTechnical
Service nearest you. Telephone numbers are
listed on Customer Support Section 9.
Note:
Run the dehydrator to dry it out prior to
connecting it to the system. Run it until the
high humidity alarm clears (if so equipped).
The drying process should take about 45
minutes, if the membrane dryer was not
saturated. If the membrane dryer was
saturated, drying may take up to 48 hours.
Caution:
High voltage exists inside the
unit. Disconnect the unit whenever
performing troubleshooting operations.
StockCheck.com

CommScope DryLine MT Series Specifications

General

Brand	CommScope
Model	DryLine MT Series
Category	Industrial Equipment
Language	English